THE CUBE KORE CARRIER BOARD | a2zRC https://a2zrc.com Thu, 13 Oct 2022 08:57:06 +0000 en-US hourly 1 https://wordpress.org/?v=6.5.5 https://a2zrc.com/wp-content/uploads/2020/04/favicon-100x100.png THE CUBE KORE CARRIER BOARD | a2zRC https://a2zrc.com 32 32 HEX KORE CARRIER BOARD https://a2zrc.com/shop/flight-controller-accessories/flight-controller/pixhaw-cube/hex-kore-carrier-board/ https://a2zrc.com/shop/flight-controller-accessories/flight-controller/pixhaw-cube/hex-kore-carrier-board/#respond Wed, 19 May 2021 11:28:41 +0000 https://a2zrc.com/shop/uncategorized/hex-kore-carrier-board/
  • The primary
    purpose of the Kore Multi-Rotor Carrier Board for The CUBE is to reduce the
    rat’s nest of wires and modules typically associated with a multi-rotor
    assembly.
  • It provides built-in power distribution, redundant power supplies for
    the autopilot, built-in fail-over power selection, a separate payload power
    regulator, and many other features.
  • While
    this carrier board is geometrically optimized for quadcopters, X8
    configurations, and octocopters, it provides connections for every function of
    The CUBE autopilot.
  • Therefore, this board can be integrated into any vehicle
    type that is supported by the CUBE, including all other multi-rotor frame
    types, plane, rover, sub, and antenna tracker.
    • The post HEX KORE CARRIER BOARD first appeared on a2zRC.]]>     Features At-A-Glance

    • Up to 12-cell Lithium
      battery (50.4V)
    • 140A continuous current with
      280A surges
    • Power and signal for ESCs
      conveniently located in corners
    • 12V navigation light power
      available at each corner
    • Built-in power distribution
    • Built-in voltage and current
      sense
    • Redundant power supplies for
      flight critical components
    • Payload connectors with resettable
      fuses for 5V, 12V, and direct battery power
    • Good power and error
      indicator lights
    • Built-in buzzer with volume
      control
    • Connectors for every
      function of The CUBE
    • Easily accessible PWM
      voltage level selector (3.3V or 5V)
    • Resistant to ground bounce
      on PWM signal
    • Connector-compatible with
      standard ProfiCNC carrier board
    • Connector ports for
      debugging IO and FMU processors

    STANDARD CABLES:

    4-pin JST GH
    6-pin JST GH

    PAYLOAD POWER CABLES:

    4-pin Clik-Mate 1.25mm (for 5V payload power)
    5-pin Clik-Mate 1.25mm (for 12V payload power)
    6-pin Clik-Mate 1.25mm (for battery payload power)

    For
    more details please call 878864106/ 6290425129/ 7001800105.

    The post HEX KORE CARRIER BOARD first appeared on a2zRC.]]>     https://a2zrc.com/shop/flight-controller-accessories/flight-controller/pixhaw-cube/hex-kore-carrier-board/feed/ 0 7764