No products in the cart.
HEX DATA MODEM RFD 900 FLIGHT CONTROLLER
- Brand: Hex
₹27,500.00₹28,000.00 (-2%)
Store a2zRC_FULFILLED
 1 in stock
- The design TXMOD is an all in one long-range telemetry data
 and RC control system.
- Designed to work in conjunction with any Radio
 Controller capable of accepting JR Transmitter Modules, the RFD TX Module can
 transmit the PPM stream from the controller to the vehicle via the RFD900X
 long-range telemetry modem while also receiving telemetry data received from
 the aircraft.
- The module’s built-in WiFi link allows for a simple webpage-based
 configuration and broadcasting of telemetry data to a computer or smart device.
- It is a JR style module that plugs into any RC transmitter that has can accept
 JR style modules (Frsky Taranis, JR, Frsky Horus) It provides a bridge between
 the RC transmitter and aircraft while carrying RC PPM data and mavlink
 telemetry streams at the same time.
Item will be shipped in 1-3 business days
Compare			
		
Frequently Bought Together
- 
Total Price: ₹40,500.00Add All To Wishlist Browse Wishlist
- This item: HEX DATA MODEM RFD 900 FLIGHT CONTROLLER(₹27,500.00₹28,000.00(-2%))
-  T MOTOR ANTIGRAVITY 4006 KV380 BRUSHLESS MOTOR(₹13,000.00₹13,500.00)
RFD900 TXMOD
Features:
- Long-range using RFD900x telemetry modem
- 2.4GHz WiFi AP / Client modes with TCP + UDP packet support
- Easy configuration by web-based wizard built-in
- Direct plug into any RC transmitter with JR style modules
 (eg. Taranis X9D, Horus, …)
- Wide range 5-18V input supply
- Optimized for use with Mavlink/Mission Planner/QGCS
- Dimensions: 52.05 x 66.94 x 38mm
RFD900x New Features:
- New Processor, ARM 32 bit core.
- Air data rate: 500kbit/s.
- AES Hardware accelerated encryption. *Fully working*
- RC PPM Passthrough with telemetry at the same time.
- Fully ESD protected + filtered – Every IO port is protected
 and filtered.
- Original SiK point to point firmware implemented.
- Asynchronous multipoint firmware, *Beta release*
RFD900x Features:
- Long range >40km depending on antennas and GCS setup
 *80km demonstrated by Edge Research labs on a balloon, 57km in India, on
 Dipoles.
- 2 x RP-SMA RF connectors, diversity switched.
- 1 Watt (+30dBm) transmit power.
- Transmit low pass filter.
- > 20dB Low noise amplifier, high IP3.
- RX SAW filter.
- All I/O ESD protected and filtered.
- Re implemented SiK and Multipoint SiK firmware, field
 upgradeable, easy to configure.
- Small, light weight.
RFD900x
Interfaces:RF : 2 x RP-SMA connectors
- Serial: Logic level TTL (+3.3v)
- Power: +5v, ~800mA max peak (at maximum transmit power)
- GPIO: 6 General purpose IO (Digital, ADC, PWM capable).
RFD900x
Specifications:
- Frequency Range: 902 – 928 MHz / 915 – 928 MHz.
- Output Power: 1W (+30dBm), controllable in 1dB steps ( +/-
 1dB @=20dBm typical ).
- Air Data transfer rates: 12, 56, 64, 100, 125, 200, 224, 500
 and 750 kbit/sec (User settable, 64kbit default).
- UART data transfer rates: 1200, 2400, 4800, 9600, 19200,
 38400, 57600, 115200, 230400, 460800, 1M baud (User settable, 57600 default).
- *note these values are correct as of version 3.07 SiK
 firmware.
- Output Power: 1W (+30dBm).
- Receive Sensitivity: >121 dBm at low data rates, high
 data rates (TBA).
- Size: 30 mm (wide) x 57 mm (long) x 12.8 mm (thick) –
 Including RF Shield, Heatsink and connector extremities.
- Weight: 14.5g.
- Power Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800
 mA peak at maximum power.
- Temp. Range: -40 to +85 deg C, tested operational from -73
 to +123 deg C.
Software / GCS
Support:
The software solution is an open source development called
“SiK”.  It has been re implemented to suit the new processor
architecture available on the 32bit ARM processor core.  A boot loader and
interface is available for further development and field upgrade of the modem
firmware via the serial port.
Most parameters are configurable via AT commands, Eg. baud
rate (air/uart), frequency band, power levels.
Integrated support for configuring the RFD900 radios is
supported by APM Planner.
The default settings are at 57600 baud, N, 8, 1, and 64k air
data rate.
Software Features
Include:
- Frequency hopping spread spectrum (FHSS)
- Transparent serial link
- Point to Point, or Multipoint networking
- Configuration by simple AT commands for local radio, RT
 commands for remote radio
- User configurable serial data rates and air data rates
- Error correction routines, Mavlink protocol framing (user
 selectable).
- Mavlink radio status reporting (Local RSSI, Remote RSSI,
 Local Noise, Remote Noise).
- Automatic duty cycle throttling based on radio temperature
 to avoid overheating.
Compliance:
- The RFD900 is designed to be compliant with the following
 standards:
- FCC Part 15.247 (Frequency hopping and digitally modulated
 intentional radiators)
- AS/NZS 4268:2012 (Radio equipment and systems – short range
 devices)
- The modem is designed for system integrators who will
 integrate the modem into their own projects and product prototypes. The
 user is responsible for compliance with local regulations for radio
 transmitters.
Applications:
- Long-range remote control (RC) via PPM
- Ground control station (GCS) telemetry gateway over WiFi
Package Includes:
- 1 x RFD900 TXMOD
- 1 x RFD900x Radio Modem
- 1 x Antenna, 868-900MHz Quarter wave monopole 2.1dBi
- 1 x Antenna, 868-900MHz Right Angle Quarter wave monopole
 2.1dBi
- 4 x Antennas, 868-900MHz Half wave dipole 3dBi
For
more details please call 878864106/ 6290425129/ 7001800105.
Only logged in customers who have purchased this product may leave a review.
No more offers for this product!                
General Inquiries
There are no inquiries yet.
 

 
                             
                
Reviews
There are no reviews yet.