HEX CUBE BLACK FLIGHT CONTROLLER

The Cube Features

Key Design Points

Separate Cube with carrier board Lets users develop their
own carrier boards

Robust interface connectors to make it easy to plug and
safer during flight

Airframes VTOL, Plane , multicopter, Traditional Helicopter,
Rover, Boat, Sub, General robotics.

Heating System to fly under low temperature

3 Redundant IMU and up to 3 redundant GPS to make it safer

Fully support Intel Edison module

Standard power brick included with the full kit

Modular design with total Flexibility on connectivity.

Increased reliability and reduced integration complexity

It comes 100% RTK GPS ready.

Multiple GPS capability is standard.

The cube ( Pixhawk 2.1 ) has a total of 29 MEMS sensors in
it
3 X 3-axis Accelerometers
3 X 3-axis Gyroscopes
3 X 3-axis Magnetometers
2 X Barometers

Mechanical: 30×30 mm M3 mounting hole pattern, 35×35 mm
footprint
80 position DF17 connector. Carries all autopilot interface connections.
● Minimal (read: really minimal) electrical protection
● No power management
● 3.8 to 5.7V operation (absolute maximum ratings)
● 4.0 to 5.5V operation (compliant rating)

Total connectivity

● I2C2
● 2x CAN: CAN1 and CAN2
● 4x UART: TELEM1, TELEM2, GPS (I2C 1 embedded), SERIAL4(I2C 2 embedded)
● 1x Console: CONSOLE (SERIAL5)
● 1x HMI: USB extender

Ports and Pins on Carrier Board

5 Serial Ports
2 CAN ports
2 I2C ports
2 Power ports
1 ADC port
8 dedicated opto capable PWM out
6 GPIO that can also be used for PWM
Dedicated Spektrum RX port
S.Bus in and out, PPM in

For more details
please call +91878864106/ 6290425129/ 7001800105.