HEX DATA MODEM RFD 900 FLIGHT CONTROLLER
- Brand: Hex
₹27,500.00₹28,000.00 (-2%)
1 in stock
- The design TXMOD is an all in one long-range telemetry data
and RC control system. - Designed to work in conjunction with any Radio
Controller capable of accepting JR Transmitter Modules, the RFD TX Module can
transmit the PPM stream from the controller to the vehicle via the RFD900X
long-range telemetry modem while also receiving telemetry data received from
the aircraft. - The module’s built-in WiFi link allows for a simple webpage-based
configuration and broadcasting of telemetry data to a computer or smart device. - It is a JR style module that plugs into any RC transmitter that has can accept
JR style modules (Frsky Taranis, JR, Frsky Horus) It provides a bridge between
the RC transmitter and aircraft while carrying RC PPM data and mavlink
telemetry streams at the same time.
Frequently Bought Together
-
Total Price: ₹40,500.00Add All To Wishlist Browse Wishlist
- This item: HEX DATA MODEM RFD 900 FLIGHT CONTROLLER(₹27,500.00
₹28,000.00(-2%)) - T MOTOR ANTIGRAVITY 4006 KV380 BRUSHLESS MOTOR(₹13,000.00
₹13,500.00)
RFD900 TXMOD
Features:
- Long-range using RFD900x telemetry modem
- 2.4GHz WiFi AP / Client modes with TCP + UDP packet support
- Easy configuration by web-based wizard built-in
- Direct plug into any RC transmitter with JR style modules
(eg. Taranis X9D, Horus, …) - Wide range 5-18V input supply
- Optimized for use with Mavlink/Mission Planner/QGCS
- Dimensions: 52.05 x 66.94 x 38mm
RFD900x New Features:
- New Processor, ARM 32 bit core.
- Air data rate: 500kbit/s.
- AES Hardware accelerated encryption. *Fully working*
- RC PPM Passthrough with telemetry at the same time.
- Fully ESD protected + filtered – Every IO port is protected
and filtered. - Original SiK point to point firmware implemented.
- Asynchronous multipoint firmware, *Beta release*
RFD900x Features:
- Long range >40km depending on antennas and GCS setup
*80km demonstrated by Edge Research labs on a balloon, 57km in India, on
Dipoles. - 2 x RP-SMA RF connectors, diversity switched.
- 1 Watt (+30dBm) transmit power.
- Transmit low pass filter.
- > 20dB Low noise amplifier, high IP3.
- RX SAW filter.
- All I/O ESD protected and filtered.
- Re implemented SiK and Multipoint SiK firmware, field
upgradeable, easy to configure. - Small, light weight.
RFD900x
Interfaces:RF : 2 x RP-SMA connectors
- Serial: Logic level TTL (+3.3v)
- Power: +5v, ~800mA max peak (at maximum transmit power)
- GPIO: 6 General purpose IO (Digital, ADC, PWM capable).
RFD900x
Specifications:
- Frequency Range: 902 – 928 MHz / 915 – 928 MHz.
- Output Power: 1W (+30dBm), controllable in 1dB steps ( +/-
1dB @=20dBm typical ). - Air Data transfer rates: 12, 56, 64, 100, 125, 200, 224, 500
and 750 kbit/sec (User settable, 64kbit default). - UART data transfer rates: 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200, 230400, 460800, 1M baud (User settable, 57600 default). - *note these values are correct as of version 3.07 SiK
firmware. - Output Power: 1W (+30dBm).
- Receive Sensitivity: >121 dBm at low data rates, high
data rates (TBA). - Size: 30 mm (wide) x 57 mm (long) x 12.8 mm (thick) –
Including RF Shield, Heatsink and connector extremities. - Weight: 14.5g.
- Power Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800
mA peak at maximum power. - Temp. Range: -40 to +85 deg C, tested operational from -73
to +123 deg C.
Software / GCS
Support:
The software solution is an open source development called
“SiK”. It has been re implemented to suit the new processor
architecture available on the 32bit ARM processor core. A boot loader and
interface is available for further development and field upgrade of the modem
firmware via the serial port.
Most parameters are configurable via AT commands, Eg. baud
rate (air/uart), frequency band, power levels.
Integrated support for configuring the RFD900 radios is
supported by APM Planner.
The default settings are at 57600 baud, N, 8, 1, and 64k air
data rate.
Software Features
Include:
- Frequency hopping spread spectrum (FHSS)
- Transparent serial link
- Point to Point, or Multipoint networking
- Configuration by simple AT commands for local radio, RT
commands for remote radio - User configurable serial data rates and air data rates
- Error correction routines, Mavlink protocol framing (user
selectable). - Mavlink radio status reporting (Local RSSI, Remote RSSI,
Local Noise, Remote Noise). - Automatic duty cycle throttling based on radio temperature
to avoid overheating.
Compliance:
- The RFD900 is designed to be compliant with the following
standards: - FCC Part 15.247 (Frequency hopping and digitally modulated
intentional radiators) - AS/NZS 4268:2012 (Radio equipment and systems – short range
devices) - The modem is designed for system integrators who will
integrate the modem into their own projects and product prototypes. The
user is responsible for compliance with local regulations for radio
transmitters.
Applications:
- Long-range remote control (RC) via PPM
- Ground control station (GCS) telemetry gateway over WiFi
Package Includes:
- 1 x RFD900 TXMOD
- 1 x RFD900x Radio Modem
- 1 x Antenna, 868-900MHz Quarter wave monopole 2.1dBi
- 1 x Antenna, 868-900MHz Right Angle Quarter wave monopole
2.1dBi - 4 x Antennas, 868-900MHz Half wave dipole 3dBi
For
more details please call 878864106/ 6290425129/ 7001800105.
Only logged in customers who have purchased this product may leave a review.
General Inquiries
There are no inquiries yet.
Reviews
There are no reviews yet.